Professional document shredder with manual paper feeder and P4 particle cut
• High-volume department document shredder
• Improves indoor climate even when the document shredder is used heavily. The unique DAHLE CleanTEC® filter system demonstrably reduces fine dust levels produced by document shredding.
• Innovative MHP® cutting rollers (Matrix High-Performance): high-quality compound steel rollers for a guaranteed long service life
• Patented manufacturing process conserves resources by using significantly less raw material compared to production of traditional cutting rollers
• Oil- and maintenance-free operation
• Higher performance and greater convenience thanks to MHP cutting rollers
• Separate CD feed opening and waste container for reliable, environmentally-friendly shredding
• Doors open wide for easy emptying of waste container
• Intuitive, user-friendly illuminated control panel with audio signals
• Device shuts down automatically after 30 minutes without use
• Electronic start and stop function controlled by integrated light barrier
• Automatic paper reverse function clears excess paper
• Convenient feeding and reversing function for manual control
• Automatic safety shut-off when the waste container is full or the door is open
• Optical waste level indicator
• Pull-out waste container
• Powerful motor ensures high performance and longer run times
• Extremely quiet operation
• Convenient swivel castors, two of which are lockable, with 5 cm ground clearance for greater mobility
• Easy-to-reach main switch on rear of device
• Practical cold-device plug can be detached from document shredder
• Entry width in mm 310

Sheet capacity (80g/sqm)* 24 – 26 sheets
Particle size (in mm) 4 x 40 mm
Run time 20min
CDs/DVDs yes
Cards yes
Paper clips yes
Waste collection volume (in l) 140 l
Noise level when idle (db(A)) 52 dB(A)
Power consumption 900 W
Speed (m/min) 4.7
Cut type Particle cut
Paper feeder manual
Security level P-4
Fine dust filter with DAHLE CleanTEC® filter system
* Maximum number of sheets which can be cut in a single pass under the following conditions: New cutting cylinders (oiled if necessary), cold motor, power supply with nominal voltage and nominal frequency (230V/50Hz, 120V/60Hz). Non-conformances can lead to a lower sheet capacity and increased running noise. Sheets are fed at 90° either portrait or landscape. The sheet capacity may vary depending on paper properties and feed.

No product videos available.
img

Required Products

Based on Category